Contents: 8,3 kg.
Water impermeability: up to a 10 m water column.
Range of use:
- For fast waterproofing of building elements, tanks, reservoirs and Basements
- Against ground damp, non-standing seepage water, in wet rooms, standing seepage water and external water pressure in accordance with DIN 18195
- Waterproofing in and under walls as a horizontal barrier against rising damp in masonry work
- Waterproofing the contact area beneath facing masonry and clinker wall positioning Areas
- Waterproofing in a bond with tiles and slab covers, indoors and outdoors (load class A0/B0
- ) Internal waterproofing according to the WTA Code of Practice 4-6
- For attaching perimeter insulation Panels
- Plinth waterproofing when com-bined with plinth render and bonded thermal insulation Systems
- Render waterproofing
- Flat roof waterproofing with a low vapour pressure gradient over rooms that are not heated / not inhabited, e.g. garages
Property profile:
- Remmers Multi-Tight 2K is liquid, polymer thick coating that com-bines the properties of a flexible, mineral waterproofing grout (MWG) and a polymer modified bitumen thick coating (PMBC): Solvent-free
- Low emissions
- Bitumen-free
- Highly flexible and crack-bridging
- Fast thorough drying and cross-linking after just 18 hours
- Can be applied as a grout, filler or sprayed
- High compressive strength
- Quickly water pressure tight, 1 bar after 18h
- Rain tight after approx. 2 hours
- Water pressure tight without a layer of reinforcement
- Visible control of thorough drying
- High tensile adhesion strength on mineral substrates and old bitumen
- Can be used on vertical and horizontal surfaces as well as beneath screeds
- Can be coated over
- UV resistant
- Resistant to de-icing salt
- Frost and age resistant
- Can be quickly subjected to foot traffic and covered (≥ 4h)
Directions
Shake the liquid component well before using. The powder component is added to the liquid component. Remove material that adheres to the side of the bucket with a trowel and mix with a suitable mixing tool until homogeneous, lump-free and the proper consistence for application with a brush or filling knife has been achieved. Mixing time is approx. 3 minutes. If required, smaller quantities can also be mixed in a ratio of 1 part by weight liquid to 1.36 parts by weight powder. The mixing ratio should not be changed. The subsequent working operations are executed as described under Applications in a brushing or filling procedure. The maximum total wet layer thickness should not exceed 5 mm. Do not use if the temperature of the air, substrate or building material is below +5 °C or above +30 °C. Relative humidity should not exceed 95%. Do not use in direct sunlight; observe the rules for the application of render according to the position the sun, remaining in the shade (pre-wet surfaces that are strongly heated) or work in the morning or evening hours. The waterproofing is sensitive to rain and frost in the fresh state.
Application rate
1 mm thickness: 2,5 kg per m2
2 mm thickness: 3,7 kg per m2