Contents: 30 liter
Range of use
- Driving rain protection for facades
- Concrete, exposed aggregate concrete, fibrated cement
- Protects against the penetration of de-icing salt
- Protects against damage caused by frost and de-icing salt
- For use outdoors
Property profile
- Improves resistance to frost/deicing salt
- Water repelling Water vapour diffusion-open
- Good penetration capacity
- UV resistant
- Alkali resistant
- Excellent long-term effect
- Solvent based
Directions
Apply the impregnation agent under gravity in a flow coating procedure generously enough (avoid misting) so that a 30-50 cm long film of liquid runs down the surface of the building material. Flow coat in sections horizontally from the top to the bottom and work in immediately with a wide brush. Repeat this process (wetin-wet) until the impregnation agent is no longer absorbed. When applying to surfaces that do not permit spray application, use a well saturated brush or roller. Protect freshly impregnated surfaces from driving rain, wind, sunshine and condensation. Remove excess impregnation agent within 1 hour with V 101 Thinner.
Working temperature: +10 °C to +25 °C
Application rate
Concrete: Approx. 0.3 - 0.5 l/m²
Light-weight concrete: Approx. 1.0 l/m²
Fibrated cement: Approx. 0.3 l/m²